Chris, You can order and use stock chrome bar ends. HVMP ( HVMP.com )also has stainless bar ends as a direct screw on that has the half moon locking end. I did a custom stainless with a HVMP set that look like stock, but also solved the bar end gap between clutch and throttle sides, thread:
http://www.cb1100forum.com/forum/showthr...?tid=11229 . I do not think the OEM bar end configuration from CB1100SA beginning thru my 2017EX has changed, but you can check the parts numbers and/or order them from
https://www.babbittsonline.com/oemparts/...ycle/parts . The part number for the chrome OEM bar ends my 2017 EX had was/is 53105-MEJ-720, and I think you will find that it is the same part number for previous years that used chrome bar ends. These will be the same OEM bar ends that Samurider has, but at a more affordable price, and without shipping from Japan. OEM bar ends are available in black or chrome, but physical configuration is the same for both finishes. Another reason I went stainless is that the OEM bar ends are cast parts. While there is nothing wrong with cast, it was just personal preference for me.